Descargar Imprimir esta página

Velleman etiampro LQS02 Manual Del Usuario página 6

Interruptor sensor de puerta - instalación en superficie - 12v/24v

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
Connect the wiring from the switch module of the infrared sensor to
the LED Strip and connect the input of the switch module to an LED
power supply. Connection diagram see page 2.
Test Operation:
Close the cabinet door and observe if the infrared sensor reflects the
signal. Then open the door to verify that the LED Strip turns on as
expected.
Optimize Placement (if necessary):
If the LED Strip does not respond consistently when opening and
closing the door, adjust the position of the infrared sensor.
Experiment with minor adjustments until the desired operation is
achieved.
Close the cabinet door and check functionality. The LED Strip should
now automatically turn on when the door is opened and turn off
when the door is
6.
Technical Specifications
Physical properties
Cable length
Maximum current rating
Input voltage rating VDC range
Detection range
IP rating
Operating temperature range
Use this device with original accessories only. Velleman Group
nv cannot be held responsible in the event of damage or
injury resulting from (incorrect) use of this device. For more
info concerning this product and the latest version of this
manual, please visit our website www.velleman.eu. The
information in this manual is subject to change without prior
notice.
V. 01 – 15/11/2023
LQS02
100 cm
3 A
12-24 V
4-20 cm
IP20
-20-45 °C
6
©Velleman Group nv

Publicidad

loading