Hisense HRM260N6TSE Manual De Operaciones página 23

3. Insert the new water filter into the hole,
and at the same time turn it about
90°clockwise until it stops.
4. Push the water filter up, and move the
cover up to horizontal and push it until
it locks.
5. Turn the water supply back on.
Turn the water supply back on.
After that, you should check the
leaks. If leaks occur, repeat the
above operation steps 1-5. If leaks
persisit, please stop using it and
call your supporting dealers.
6.Flush filter for 5 minutes before use.
Removing any residual matter
inside the water supply line
1. Turn on the main water supply and
supply water from water supply line.
2. Let the water flow through the
dispenser until it becomes clear
(flush for approximately 5 minutes).
This will clean the water supply
system and remove the air from the
lines.
3. Additional flushing may be required
in some households.
4. Open the refrigerator door and
make sure there are no water leaks
coming from the water filler.
Note
23