Storage; Transportation; Dimensions Of Wear For Diameters And Lengths Of The Pokers - ENAR VGR6 Manual De Instrucciones

for 2 minutes to allow running it in. Do not overlubricate, it could cause the grease penetrates into
the poker, or overforces the motor. Do not clean the flexible shaft with solvent. Ask the manufacturer
the type of grease that must be used.
4. Every 300 hours of working is recommended to clean the poker. To clean the poker dismount
the cap. Hold the housing on a vise and tap the cap with a hammer. This will help to break the
seal and to loosen the threads. Clean the cap and cones with a solvent and fix again with
Loctite 243 or equivalent. If rests of grease are inside change the gaskets following point 5.
5. To do maintenance follows the following steps:
- Flush the parts with solvent and wipe all part. It is very important to keep the cones clean.
- Examine bearing and seals. If inspection reveals that grease of transmission has
penetrated into the head, the oil seals must be replaced. When replacing the seals, mount
them in the same direction (neoprene seal lips must face the hose side).
- The purpose of the seals is to keep the flexible shaft grease out from the poker. Be careful
not to damage the polished surface where the seals are assembled. Once the seals are
dismounted it is recommended to replace them.
- Apply sealant before assembling and fix the O-ring. Tighten and clean the excess of
sealant. It is important that all the parts are tightened to avoid water and concrete get into the
head.
6. After maintenance works and service, all the parts must be assembled correctly.
7. Every 12 months or more frequently, depending on the usage conditions, it is recommended to
make an inspection by an authorized dealer.

6.4 STORAGE

When the equipment is not used for long periods of time, it should always be stored in clean, dry,
and protected areas.

6.5 TRANSPORTATION

When transporting by vehicles, ensure the equipment is safe against slipping, overturning and blows
7 DIMENSIONS OF WEAR FOR DIAMETERS AND LENGTHS OF
THE POKERS
MODEL DIAMETRE (mm)
ANR25
ANR38
ANR48
ANR58
ANR70
A. The minimum dimensions are bold printed.
B. The dimensions into brackets are the original dimensions.
C. Replace the tube when it reaches the minimum diameter.
D. Replace the tip when it reaches the minimum length.
PETROL ENGINE-ELECTRIC MOTOR-FLEXIBLE SHAFT AND POKERS
VGR6, VGH5, VGE5, VYD, VHD, VLD - VPA, VPAME - TNR - ANR
LENGTH (mm)
23,5 (25) 325 (330)
36 (38) 351 (356)
45,5 (48) 424 (429)
55,5 (58) 442 (449,5)
67,5 (70) 510 (518)
en
.
11