Humanscale M/Connect 3 Instrucciones De Montaje página 7

Sliding Desk Mount
Slide unit with loosely mounted bracket against work surface edge. ①
1
Tighten both set screws(B) evenly into bracket to a snug fit. ②
2
①
Bolt-Through Mount
1
Drill 1/2" hole in desired location
NOTE: To ensure M/Power makes full contact with desk, locate hole at least 2" away from back edge of desk.
Lower M/Power onto desk aligning bolt with hole. ③
2
Slide the Bolt-Through Plate (C) over the bolt and tighten the nut ➃
3
Place the protective cap (D) over the bottom of the bolt. ➃
4
③
½ inch hole
②
B
➃
C
D
7