Publicidad
Idiomas disponibles
Idiomas disponibles
Product Installation
Installation of 2-in-1 Water Tank and Mop Holder
1. Take out the 2-in-1 water tank, and open the rubber cover. Fill
clean water and close the rubber cover. Do not soak or rinse the
2-in-1 water tank.
2. Wring the mop dry and install it on the mop holder.
3. Align the positioning holes, and install the mop holder at the
bottom of the 2-in-1 water tank, as indicated in the figure.
4. Install the 2-in-1 water tank into the main unit and confirm
that buckles are installed in place, as indicated in the figure.
Notes:
Do not inject hot water into the 2-in-1 water tank to avoid deformation.
Do not rinse or soak the 2-in-1 water tank! Never use detergents, disinfectants, and
solid detergents, in order to prevent the 2-in-1 water tank from corrosion and
blockage.
Take out the 2-in-1 water tank and fill clean water through the water inlet.
Apply the mop function after wetting the mop, wringing it dry and then installing it
into the mop holder. After mopping, pour out the remaining water in time, and
clean and dry the mop to avoid odor and mold.
Do not apply the mop function when there is no one at home.
There may be a little water in the 2-in-1 water tank due to production testing. This
is a normal phenomenon.
10
Publicidad
