Publicidad
Put the hot dryer only on heat resistant surfaces and away from clothes, flammable liquids or paper.
Do not obstruct the ventilation openings as this may seriously damage the engine. At this purpose, be careful
not to bring the hair near such openings, as they may be sucked into the dryer and burnt.
Never leave the appliance unattended while it is running.
In case of overheating, which may be due to excessive use and accidental obstruction of the ventilation, the
safety thermostat will stop motor from running. Wait for complete cooling of the engine before turning on.
While the dryer is working, the airflow concentrator becomes hot. Do not touch it, it may cause
serious burnings.
Do not use unit as a heater. Do not use in humid ambients
Do not wrap the power cord to the unit during use.
After every use, wait for the product to completely cool down before storing it.
If you use the hair dryer in a bathroom you need to unplug it after use since the proximity of water can be
dangerous even when the dryer is turned off.
In order to ensure a better protection, it is advisable to install in main electrical circuit supplying the local
bath, a device to differential current, not greater than 30mA. Contact your technician for more information
Do not keep appliance switched on continously for more than 2 minutes. Bring knob on "0" (OFF) position
before inserting the plug in the socket.
Do not grab the product near to the air outlet, use the handle. Keep at least at 5cm from the head
DESCRIPTION PH03
1. Air outlet
4. Cool-shot button
OPERATING
-
Set the power switch (5) to "0" and plug the dryer into the power outlet.
-
This dryer operates with 2 speeds and 3 temperatures: set button (5) to "I" for low speed and temperature,
to "II" for high speed and temperature
-
Caution: air concentrator (1) heats up quickly. When the dryer is running, do not touch it.
-
At the end of drying process, set the power switch (5) to "0" position.
-
Let the hairdryer cool down completely. (Approximately 10 minutes)
-
Once the unit is completely cold, store it out of the reach of children.
Cool-shot
The hair dryer constantly delivers a flow of hot air. Pushing the "Cool-shot" button (4), the internal resistance
will be temporarily disabled and in a few seconds the device will blow air at room temperature.
INSTALLATION AND ASSEMBLY
The assembly and installation must be done by following a few instructions.
- The appliance must be placed high enough to be out of the reach of children (at least 200cm from the floor).
- The appliance must be placed at a minimum distance of 50 cm from the sidewalls.
- Do not mount on a vibrating surface. Place out of the reach of air splashes.
CAUTION! The plugs and screws supplied are only suitable for mounting on
masonry walls. If you decide to install the unit on another type of wall
(plasterboard or other), buy appropriate anchors.
- Take the support (6) and remove the hairdryer; place support on the wall in the
desired location.
- Mark on the wall the positions corresponding to the two holes present in the
support (6). Check that the marks are aligned at 90mm from each other.
- Drill two holes (diameter 6mm) in the wall and insert the dowels into the holes.
- Place the support (6) with the holes over the dowels and use a screwdriver to
insert the screws, and tighten to fix the product to the wall. Place the hairdryer in its seat.
A support and third dowel are also included, to be used only in case of mounting on surfaces that are
not particularly load-bearing.
2. Main body
5. Speed control switch
3. Air inlet
6. Support for wall mount
9
Publicidad
