Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
PROBLEM
The cleaner don't capture
debris.
Garbage flows out from the
bottom of the transparent
component
Garbage leaking out of the
filter bag
Switch not working or out
Handle/pole connector
cannot be secured in
assembly
Cleaner unable to charge
POSSIBLE CAUSES
The battery is low
Impeller blockage
Impeller damage
Garbage blocking the
suction port
The filter bag is full
The filter bag is full,
Backflow of water flow
The anti backflow plate
is broken
Filter bag is broken
Damaged circuit board
Battery depletion /
damage
Motor damage
There is rubbish around
the sener or senser
oxidataion
V-Shape clip broken
Battery damage
Charger damaged
When the switch light is on for 2 seconds and off for 1 second,
it will flash slowly for 10 times and stop the machine to turn off
the light. Turn off the light and recharge. Once the charging is
complete, turn off the switch and restart it to operate normally
for more than 75 minutes.
When the rotor is blocked, the switch light flashes continuously
at 0.5 second intervals, and the motor stops. Check the impeller
and clean the stuck leaves or stones by hand if found stuck.
Then, turn off the switch, turn off the light, and restart the
switch to ensure normal operation.
Please contact your dealer for replacement.
Clean the garbage
Clean the garbage
Clean or replace the filter bag
Replace the anti backflow plate
Replace the filter bag
Please contact your dealer for replacement.
Recharging/Please contact your dealer for replacement.
Please contact your dealer for replacement.
Cleaning the senser by a paper, or a cloth, or a brush
Using the new V-Shape clip
Please contact your dealer for replacement.
Warning! Please purchase the original lithium battery for
replacement to avoid damage to the cleaner.
Please contact your dealer for replacement.
Warning! The wrong charger will cause damage to the machine
and battery, and this situation is not guaranteed.
SOLUTION
Publicidad
