Assembly Of The Accelerator And Connection Of The "Dead Man" Safety System (Tifón 900H And Tifón 1200H) - ENAR TIFON 600 Manual De Instrucciones

8 ASSEMBLY OF THE ACCELERATOR AND CONNECTION OF THE
"DEAD MAN" SAFETY SYSTEM (TIFÓN 900H AND TIFÓN 1200H)
Power trowels TIFÓN 900H and TIFÓN1200H are supplied with the accelerator and the "dead man"
safety system disassembled, so they must be assembled and connected before working. To do this,
firstly it is necessary to connect the accelerator cable to the engine. Remove the cover of the filter
and then remove the filter. Fix the accelerator cable cover with its clamp (as shown in the picture
below) and put the accelerator cable into the prisoner of the engine:

COVER OF THE
FILTER
Once the accelerator is assembled, connect the "dead man" safety system as shown in the picture:
To check the "dead man" safety system works correctly, start the engine with the lever of the safety
system pulled. Once the machine is working, release the lever; the machine must stop working. If the
machine doesn't stop working, check again the connections of the safety system.
TROWELS WITH ELECTRIC OR PETROL ENGINE

REMOVE THE
FILTER
SWITCH
CABLE FROM THE
HANDLE

REMOVE
CABLE COVER CLAMP
PRISIONERO
ACCELERATOR ASSEMBLY
PRISONER
en
15