Descargar Imprimir esta página

Bissell POWERLIFTER REWIND 1792 Serie Guia Del Usuario página 6

Publicidad

Idiomas disponibles

Idiomas disponibles

Tools
NOTE:
Crevice Tool and Extension Wand come pre-installed on the back of the vacuum.
The Pet Hair Eraser Tool and Dusting Brush do not store on the vacuum.
Operations: Power On & Settings
1
To power ON, step on
the RED Power Switch
Pedal located near the
bottom and center on
the back side of the
unit. Push the lower
Handle Recline Pedal
two times for an even
lower recline.
6
www.BISSELL.com
To attach any of the
included tools, remove
the lower wand base
from the foot of the
vacuum and from
both hose clips. Insert
the desired tool firmly
into the hose end.
Pet Crevice Tool
Use END side as
standard crevice tool.
Twist to SIDE to open
up suction across
rubber fingers for
upholstery and large
surface areas.
Extension Wand
Attach with desired
tool for longer reach.
2
Turn dial on foot to adjust to 1 of 5 height adjustments.
NOTE: For optimal cleaning, adjust to the lowest
practical setting. If your vacuum is difficult to push, or is
pushing larger debris, adjust to the next higher setting.
Dusting Brush
Use brush to dust furniture,
blinds, books, lamps,
shelves and baseboards.
Pet TurboEraser™ Tool
Remove tool by pulling
away and downwards
from vacuum. For best
use, press the brush gently
down and pull towards you
in raking motion; too much
pressure will cause brush to
stop rotating.
Pet Hair Eraser™ Tool
Move sweeper from side
to side. When you hear
"click", reverse the motion.
Clean inside the dirt bin
by pressing on the side
tabs gently to open. You
can use a damp cloth
or towel to clean excess
dirt and any excess hair.
Connect the hose to use
with the vacuum or you
can use without the hose
connection.
Lowest Setting: For low pile
carpet and bare floors.
Medium Setting: For medium
pile carpet.
Highest Setting: For high pile
and most shag carpet. Adjust to
high setting if difficult to push.

Publicidad

loading