Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
LOADING FASTENERS
LOADING INSTRUCTIONS
A fastener can be driven unintentionally if the trigger
and safety bracket are activated at the same time.
Always disconnect tool from air supply before loading
fasteners, making adjustments, or performing any service
on tool. Keep finger off trigger until ready to drive a fastener.
1. Pull pusher (A) back to latched position
at rear of magazine.
2. Load staple strips (B) over magazine track.
Slide strips down so that staple crowns
ride on top rail, then slide forward toward
tool nose.
3. Pull pusher (A) back and press release
lever to release latch. Slide pusher
forward against staple strips and release.
DO NOT allow pusher to snap forward
against staples.
4. Tool is now loaded and ready to be
connected to an air supply for operation.
5. Reload when indicator triangles on
magazine and pusher are aligned.
CLEARING STAPLE JAMS
1. Disconnect tool from air supply
using quick-connect coupling.
2. Pull pusher back to latched position
at rear of magazine.
3. Open E-Z Clear latch and open door.
4. Remove jammed fastener.
5. Close door and secure with latch.
6. Release pusher and slide forward
against staple strips.
7. Connect air supply and check tool
for normal operation.
GRTSM2016C_OwnersManual007_ENGES.indd 10
DANGER
10
4/19/19 10:47 AM
Publicidad
