Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
Your tool will last longer and perform better if periodic maintenance
is performed. Please use the information below to keep your tool
operating in top condition.
LUBRICATION
Disconnect tool from the air supply and remove all
fasteners. Apply 2 - 3 drops of air tool oil (provided)
in the air inlet two - three times a day. If the tool will
be used outside in the winter, use a winter grade air
tool oil to help keep frost from forming inside the
tool. Do not use other types of lubricants on this
tool, as other lubricants may contain chemicals
harmful to o-rings and other tool components.
Drain compressor tanks and hoses daily.
CLEANING
Disconnect tool from the air supply and remove all fasteners.
Brush tool off using a parts cleaning brush or clean rag. Check area
around trigger and workpiece contact, and clean as necessary.
Pull pusher back to latched position, and brush out staple entry area
of tool nose. Open E-Z Clear latch and brush out debris. Blow out
confined areas around tool nose using low pressure compressed air.
TRIGGER CHECK
Check trigger operation daily:
1. Press the workpiece contact against a safe work surface without
depressing the trigger. THE TOOL MUST NOT CYCLE.
2. Hold the tool above a safe work surface and pull the trigger without
depressing the workpiece contact. THE TOOL MUST NOT CYCLE.
3. The trigger must return to the normal position each time finger
pressure is released.
GRTSM2016C_OwnersManual007_ENGES.indd 13
13
OPERATION
4/19/19 10:47 AM
Publicidad
