Status Window; Error Codes - Heartland HCTTDW Instrucciones De Uso

Status window

That STATUS window displays codes typically seen during
normal operation or programming of the dishwasher. The
STATUS window indicates the following activity:
1HR-24HR - Indicates num-
ber of delay start hours for
selected cycle.
CLOSE DOOR - Flashes
once the program has been
entered and the START pad
is pressed. It also flashes if
the door is opened during a
wash cycle. Close the door
to begin or continue the
wash cycle.

Error Codes

Displayed
Error Code
i10 A low fill has been detected.
Clogged filters or a restricted drain line
i20: i40; iF0
A leak or overflow of water has been
i30
detected in the bottom pan.
A problem has been detected with the
i50
A problem has been detected with the
i60
A problem has been detected with the
iC0
* In all Error Code instances, if Pressing the cancel but-
ton or turning power off at the breaker for 5 min. does not
resolve the problem, contact the AGA Marvel customer
service at 1-800-223-3900.
OPERATING INSTRUCTIONS
Child lock is activated.
MIN - The cycle duration or
the remaining time.
LI - L4 - Level of rinse aid
dosage.
CLEAN - End of cycle.
Problem
has been detected.
drain or wash motor.
water heating system.
electronic control system.
Display on floor
The display on floor indicates the following activities:
Look for a pinched water supply line, or water shutoff is not
completely opened.
Check and clean both filters and sump area and check for a
pinched or blocked drain hose. If the drain line is attached to
a disposer, check that the knockout plug has been removed.
Look for loose connections at the water inlet valve and en-
sure the unit is properly leveled.
Pressing the cancel button or turning power off at the break-
er for 5 min. should clear this error code and the unit can be
restarted.
If this does not resolve the problem, service will need to
be called.
8
The cycle duration remaining
time.
Remaining time of Delay start
End of cycle
Error codes
Solution