BTS Y1-4000D Manual De Usuario página 36

j. Water supply-Electric contact pressure gauge
Power incoming Ііnе
АСЗ80V
a.Connect the pressure gauge wire to the terminal G) (2) QJ
b.lndicator "Middle" -gauge not connected or wrong connection
c.lndicator" High" -please exchange the terminal wire G) with QJ
d.lndicator" Low" -please exchange the terminal wire (2) with QJ
-17-
lnstall the pressure gauge
at 3-5 meters from the
water outlet side
· Make high pressure little
higher than normal condition.
· Make Low pressure little
lower than normal condition
but higher than pressure
of по water.
Electric Contact
-
Pressure
Pressure Gauge
tank
B uffer
bend
К. Water supply-Pressure switch
•
Power incoming line
АСЗ80V
a.lf setting pressure switch disconnected, pump stop. Please connect the
lnput & Output wire of pressure switch with terminal®®·
b.lf setting pressure switch disconnected, pump start. Please connect the
lnput & Output wire of pressure switch with terminalCDФ.
Make the button to the
Water level position
Pressure
tank
-18-