Descargar Imprimir esta página

Ribimex PRPF50 Manual De Instrucciones Y Mantenimiento página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

18. Defective switches or other part that is damaged should be properly repaired or replaced by an
authorized service centre. Do not use the product if the switch does not turn it on and off.
19. Warning
The use of any accessory or attachment, other than those recommended in this instruction manual,
may present a risk of injury to persons or animals and may cause damages.
The user and/or operator are responsible for any damages or injury caused to properties and/or
persons.
20. Have your product repaired by a qualified person
Unless otherwise indicated in this instruction manual, repairs or replacement of any damaged part in
an authorized service centre is recommended.
This electric product is in accordance with the relevant safety requirements. Repairs should only be
carried out by qualified persons using original spare parts, otherwise this may result in considerable
danger to the user.
21. Remarks:
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product especially
for any matters that are not referred in the above.
3.2- Special warnings when using the pump
1. Become familiar with the controls and the proper use of the equipment.
2. The use of this product by children, without adult supervision, is forbidden.
3. Only well-instructed adults should operate the product.
This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved.
- children shall not play with the appliance.
- cleaning and user maintenance shall not be made by children without supervision from an adult
.
4. The supply voltage should correspond to that given on the description label (230 V-50Hz).
5. The pump should be supplied by a circuit containing a residual current circuit breaker (RCCD)
with a sensitivity not exceeding 30 mA. Consult a qualified electrician.
6. The supply cable should be checked periodically and before each use to see if there are any signs of
ageing or damage.
If the power cable is damaged, it must be replaced by the manufacturer, its after sales service or a
person with similar qualification in order to avoid any danger.
If the power cable or extension cord is damaged or cut during operation, immediately disconnect plug
from its main power source. Do not touch the cable or extension cord before unplugging from main
power.
7. If the pump is not in good condition, do not use it. Have it repaired by an authorized centre.
8. If an extension is used, ensure that it is officially approved. Keep it well away from sharp edges,
heat sources and combustibles
The plug-in connector for the extension should be of the 2 pole + earth type of 10-16A/250V, in
accordance with CEE standards. The wire section in the cable should be equal to or greater than
2
0.75mm
. The cable should not be lighter than cables of H05 RN-F type
9. If the pump is used in a pond, it should not be used when there are people in the pond.
10. When the pump is immersed, handling should not be carried out using the power cable.
11. Do not use the pump in extra chlorinated water or in acidic or basic liquid which could damage
and affect the service life and particularly that of the connecting cable.
12. Before any intervention, disconnect pump from the electrical power source.

Publicidad

loading

Este manual también es adecuado para:

516836