Publicidad
Idiomas disponibles
Idiomas disponibles
NARROW TILLING/CULTIVATING
- 12-3/4"
PATH
• Remove outer tines.
o
o
Oll
Iio
... _
dr"..
x
Inner Tines Only
ooi
tine
6
NOTE:
When
reassembling
outer tines,
be
sure right tine assembly
(marked
"R") and
left tine assembly
(marked
"L') are mounted
to correct
side of tine shaft.
TINE
OPERATION
CHECK
_ILWARNING:
Disconnect
spark
plug
wire from spark
plug to prevent
starting
while
checking
tine operation.
For proper
tine operation,
forward
tine
control
lever must
be against
control
body
and all slack
removed
from
inner wire of
control
cable
when
control
is in the "OFF"
(up) position.
Reverse Tine Control
Reverse Tine Control
"Off" (UP)position/"On"
(DOWN)Position
Body
\
Forward Tine
Control "Off"
(UP) Position
Tine Control Cable
Forward Tine
Control "On"
(DOWN) Position
Cable
Clip
\
\
• If tines rotate,
inner wire of control
cable
is too tight which
is extending
lower
spring
and engaging
tines.
Loosen
cable
clip and push
down
on cable
only enough
to relieve
spring
tension.
Tighten
cable
clip.
• Recheck
in "OFF"
position
and adjust
if
necessary.
FINAL
CHECK
"ON"
POSITION
• With tine control
"ON"
(held
down
to
handle)
push
down
on handle
to raise
tines
off the ground.
• Slowly
pull recoil
starter
handle
while
observing
tines.
Tines
should
rotate
forward.
• If tines do not rotate,
inner wire of con-
trol cable
is too loose.
Loosen
cable
clip and pull cable
up to remove
slack
and retighten
clip.
• Recheck
in "ON"
position
and adjust
if
necessary.
NOTE:
If "ON"
position
check
required
adjustment,
recheck
"OFF"
position
adjustment
to insure
tines do not rotate
when
control
is "OFF"
(up).
TO REMOVE
BELT GUARD
• Remove
two (2) cap nuts and washers
from
side of belt guard.
• Loosen
(do not remove)
tine shield
nut
on underside
of tine shield.
• Pull belt guard
out and away from
unit.
• Replace
belt guard
by reversing
above
procedure.
Be sure slot in bottom
of
belt guard
is under
head of tine shield
bolt and all nuts are tightened
securely.
;ap Nuts and
Washers
Belt
If lever and cable
are loose,
loosen
cable
clip at lower
end of cable.
Pull up on
cable
to remove
slack,
without
extend-
ing spring
on end of cable,
and retighten
cable
clip.
FINAL CHECK "OFF" POSITION
With tine control "OFF" (up), push down
on handle to raise tines off the ground.
Slowly
pull recoil
starter
handle
while
observing
tines. Tines should not rotate.
15
TO REPLACE V-BELTS
Replace
V-belts
if they have stretched
considerably
or if they show
cracks
or
frayed
edges.
There
are two (2) V-belts
-
forward
(inside)
and reverse
(outside).
Belt guard
must
be removed
to service
belts.
See "TO REMOVE
BELT GUARD"
in this section
of manual.
NOTE:
Observe
carefully
routing
of both
belts and location
of all belt guides
before
removing
belts.
Publicidad
