Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATOR'S
POSiTiON
When
right or left hand is mentioned
in this
manual,
it means when you are in the operat-
ing position
(standing
behind
tiller handles).
Front
Left
Right
Cable
Tiller
Handle
Panel Bolts
Hex Bolts
5/16-18 x
1-1/4"
Operator's
Position
UNPACK
CARTON
& INSTALL
HANDLE
AI:_CAUTION:
Be careful
of exposed
staples
when
handling
or disposing
of
cartoning
material.
IMPORTANT:
When
unpacking
and as-
sembling
tiller, be careful
not to stretch
or
kink cable(s).
1.
Cut cable
ties securing
handles.
2.
The handle
may be assembled
in high
or low position.
Slowly
lift handle
as-
sembly
up and align handle
holes
with
desired
handle
panel
hole and slot.
3.
Loosely
assemble
hardware
as shown.
NOTE:
Cables
must not touch
the muffler.
4.
Cut cable
ties securing
tiller to skid
and remove
tiller from skid.
5.
Remove
screws
securing
depth
stake
to skid and discard
screws.
INSTALL
DEPTH
STAKE
ASSEMBLY
1. Loosen nut"A".
2. Insert stake support
between
engine
bracket halves with stake spring down.
3.
Bolt stake support
to engine brackets
with bolts, Iockwashers and nuts. Tighten
securely. Tighten nut "A".
4.
Depth stake must move freely. If it does
not, loosen support
bolt.
Engine Bracket Halves
Nut "A"
epth Stake Support
Support
Bolt
Depth
Stake
Spring
Hex Bolts,
Lock Washers, and Hex Nuts
HANDLE
HEIGHT
• Handle
height
may be adjusted
to better
suit operator.
(See "HANDLE
HEIGHT"
in the Service
and Adjustments
section
of this manual).
TILLING
WIDTH
• Tilling
width
may
be adjusted
to better
handle
your tilling
conditions
(See "TINE
ARRANGEMENT"
in the
Service
and
Adjustments
section
of this manual).
TI
@
NE OPERATION
Checktine
operation beforefirst use. (See
"TINE OPERATION CHECK" in the Service
and Adjustments
section of this manual).
7
Publicidad
