KNOVA KN AP-125B Manual Del Usuario página 3

BENCHTOP PLANER SPECIFIC SAFETY INSTRUCTIONS
WARNING
The safety instructions given above can not be
complete because the environment in every shop is
different. Always consider safety first as it applies
to your individual working conditions.
• ALWAYS read and understand the user manual before
operating the planer.
• DO NOT plane materials such as plywood, hardboard,
fiber board or any other material than solid natural wood
fiber.
• ENSURE that all parts are assembled and adjusted
properly before turning the planer ON.
• KEEP your fingers away from the infeed roller while
feeding the stock into the cutter head.
• ALWAYS inspect your stock for nails, staples, pieces of
stones or any other foreign material which is dangerous
if comes in contact with the cutter head.
• DO NOT plane stock with loose knots.
• DO NOT removes more than 1/8" from the surface of
the stock in a single pass.
BENCHTOP PLANER PHYSICAL FEATURE
Reset
switch
ON/OFF
switch
Cuttrhead
& motor
assembly
Retum
rollers
Infeed
extension wing
• ALWAYS plane in the same direction as the grain of
the wood.
• ALL GUARDS must be in place while operating the plane
to ensure safety.
• ALWAYS feed stock smoothly. Do not force or twist
the work-piece while planning.
• DO NOT looks inside the planer while feeding
the work-piece into the cutter head.
• MAKE SURE before making any adjustments, the switch
is in the "OFF" position and the cord is un-plugged.
• NEVER LEAVE the planer unattended while it is running.
• DO NOT attempt to remove jammed pieces unless
the power switch has been turned to the OFF position
and cord is unplugged from the power source and the
cutter head has come to a complete stop.
• ALWAYS make sure that the planer is in a stable position.
• DO NOT operate the planer using dull or damaged knives.
• MAKE SURE you have read and understood all the safety
instructions in the manual and you are familiar with your
planer, before operating it. If you fail to do so, serious
injury could occur.
Front motor
brush
Mounting
hole
2
Crank
handle
Lifting
handle
Depth of
cut scale
Rubber
feet