Ferm HAM1019 Traducción Del Manual Original página 6

continues to run. When the heater has cooled to
operating temperature, the heater is switched on
again.
Switching off:
Slide the switch to 0.
Tip: If you want to get the best result, test all
appliances on a little part of the workpiece.
Flat rear side
Fig. C
Inbetween usage, the machine can easily be
placed on its flat rear side (6). This prevents any
hot area from the machine getting into contact
with other surfaces
The flat rear side (6) also allows the machine to
be used in upright stationary mode. After usage,
always place the machine on its flat rear side (6).
This allows the machine to cool down safely.
Use of accessories
Fig. B
Fishtail nozzle (4)
Distributes air equally over flat wide area.
Glass protection nozzle (5)
Deflects air away from glass for example when
stripping paint in window frames or softening
putty.
4. MAINTENANCE
Always disconnect the apparatus before
carrying out inspection or cleaning.
Never use water or other liquids to clean
the electrical parts of the hot air gun.
• Never use easy inflammable liquids for
cleaning the hot air gun, especially for the
mouthpiece.
• Regular maintenance of your hot air gun
prevents unnecessary problems. Keep the
ventilation slots of the hot air gun clean to
prevent overheating.
6
Troubleshooting
In case the hot air gun does not work well, we give
you subjoined some possible causes and their
solutions.
• The engine gets overheated.
• The ventilation slots of the hot air gun are dirty.
• Clean the ventilation slots.
• The hot air gun does not start when it is
switched on.
• Interruption in the electrical circuit.
• Check the mains lead and the mains plug.
• The switch is defective.
• Pull the mains lead out of the wall socket,
because there is a chance of fire risk! Have
the hot air gun repaired at your local dealer.
• The engine does not work, but it does heat.
• Interruption in the electrical circuit.
• Pull the mains lead out of the wall socket,
because there is a chance of fire risk! Have
the hot air gun repaired at your local dealer.
ENVIRONMENT
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material. Therefore
please make use of options for recycling the
packaging.
Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2012/19/ EC for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
GUARANTEE
The guarantee conditions can be found on the
separately enclosed guarantee card.