EN
Safety Instructions
• Position on a flat, stable surface.
• A service agent/qualified technician should carry out
installation and any repairs if required. Do not remove any
components on this product.
• Consult Local and National Standards to comply with the
following:
- Health and Safety at Work Legislation
- BS EN Codes of Practice
- Fire Precautions
- IEE Wiring Regulations
- Building Regulations
• Caution! Hot surface! The temperature of accessible
surfaces may be high when the appliance is operating.
• DO NOT immerse the appliance in water.
• Do not clean with jet/pressure washers.
• Do not move or carry the appliance when it is switched on.
• DO NOT leave the appliance unattended during operation.
• DO NOT obstruct or cover the appliance in any way when in
use.
• The appliance should not come into contact or be covered with
easily flammable materials, like curtains, textiles, walls and
the like. Always ensure sufficient safety distance to flammable
materials.
• Always switch off and disconnect the power supply to the
appliance when not in use.
• Not suitable for outdoor use.
• Keep all packaging away from children. Dispose of the
packaging in accordance to the regulations of local authorities.
• DO NOT use if damaged.
• If the power cord is damaged, it must be replaced by a Buffalo
agent or a recommended qualified technician in order to avoid
a hazard.
2
FA118_ML_A5_v3_20230627.indb 2
FA118_ML_A5_v3_20230627.indb 2
2023/6/27 15:14:39
2023/6/27 15:14:39