Buffalo FA118 Manual De Instrucciones página 4

EN
Mounting the air pipe and brushes
Air pipe:
1. Mount the air pipe onto the base. Rotate until its hole is aligned with the hole on the base.
2. Tighten the air pipe with the screw provided.
Brushes:
1. Mount the brush onto the shaft.
2. Rotate the brush anti-clockwise to let the pin on the shaft get locked into the brush's notch.
Note:
• Among the 5 brushes, ensure to mount the short one onto the centre shaft.
• During operation, hot air will come out from the air pipe slot to keep brushes dry so
as to maintain a good polishing effect. It is essential to always keep the brushes dry;
wet brushes do not dry or polish the glass. During intensive use, if the brushes become
damp, run the appliance without glass for 20 minutes to allow the hot air to dry the
brushes.
4
FA118_ML_A5_v3_20230627.indb 4 FA118_ML_A5_v3_20230627.indb 4 2023/6/27 15:14:40 2023/6/27 15:14:40