Publicidad
Idiomas disponibles
Idiomas disponibles
06 Initial Setup
The initial setup dialogue box appears when the TV is first activated. Follow the on-screen instructions to finish
the initial setup process. You can manually perform this process at a later time in the
Start Setup menu.
• If you connect any device to HDMI1 before starting the installation, the Channel Source will be changed to Set-
top box automatically.
• If you do not want to select Set-top box, please select Aerial.
Using the TV Controller
You can turn on the TV with the TV Controller button at the bottom of the TV, and then use the Control Menu. The
Control menu appears when the TV Controller is pressed while the TV is On. For more information about its usage,
refer to the figure below.
Motion Sensor
• When you press the TV Controller button, be careful not to press the motion sensor close to it.
• The remote control sensor LED remains on in the standby mode of TV mode and off in the standby mode of Art
mode.
• After detaching the Customizable Frame (sold separately) from the TV, push up the remote control sensor so
that it returns to its original position.
– Do not push up the remote control sensor strongly. There is a risk of damage.
English - 18
Control menu
: Power off
: Channel Up
: Channel Down
TV Controller / Remote control sensor
• TV mode
– Press: Move
– Press & Hold: Select
• Art mode: Switch to the TV mode
The TV Controller is located on the bottom of the TV.
>
Settings > General >
: Volume Up
: Volume Down
: Source
Publicidad
