BECKETT SUBMERSIBLE PARTS WASHER PUMP
All GP pump models feature a unique manufacturing process that provides an extra margin of safety while protecting the environment.
Beckett GP pumps are non-oil filled pumps, and feature a completely encapsulated motor, which prevents any current leakage onto
electrical connections. The Beckett GP pumps are intended for use only in Underwriters Laboratories (UL) listed parts washers.
•
The Beckett GP210C, GP325CH, GP325C1 & GP325C1P pump are suitable for circulating unheated stoddard solvents and
aqueous cleaning solutions.
The use of any other liquid constitutes a special application and may void the warranty.
•
These pumps are thermally protected and they are designed for only submerged operation for proper cooling.
•
A conduit must be attached to the builder's fitting of the pump to protect the electrical cord. Failure to install a water tight conduit
may void the warranty.
CAUTION:
Do not let the pump operate dry.
•
Risk of electric shock –To reduce the risk of electric shock, be certain that the Pump is connected only to a properly
grounded, grounding-type receptacle.
•
The electrical cord must be protected by a liquid tight conduit.
•
Before servicing or handling pump, make sure the pump is disconnected from the power source.
•
Do not connect unit to any other voltage than shown on the pump.
•
Always disconnect the appliance from the supply before assembling, disassembling, or cleaning.
•
Appliances can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and if
they understand the hazards involved.
•
Children shall not play with the appliance.
•
Pumps without indication that they are protected against the effect of freezing shall not be left outside during freezing
weather conditions.
OPERATING INSTRUCTIONS
Models: GP210C, GP325CH, GP325C1 & GP325C1P
INTRODUCTION
OPERATION
WARNING!
90013
Rev.10