Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH / INTRODUCTION
Thank you for choosing our brand. We hope that the welding machine you have purchased will serve you well. This
instruction manual contains the necessary information and warnings for correct use within the maximum operator
safety conditions. INVERTER welding equipment must be used by expert personnel who know and understand the
risks involved in the use of this equipment. If you have any doubt or queries concerning this manual, please, contact
us. Internal manipulation of the equipment involves the risk of electric shocks and also voids warranty. We request you
not to carry out any manipulation of the equipment (only technically trained personnel by Solter Soldadura S.L. can do
this). Solter Soldadura S.L. denies all responsibility for negligent practices in the use or manipulation of this machine.
This manual must be kept with the equipment purchased. It is the responsibility of those persons who use and repair
this machine to comply with the requirements of the above mentioned regulations.
SAFETY AND PROTECTION
ELECTRICITY
A good and safe installation is essential to ensure the optimum performance of this equipment. Make
sure that the unit is connected to the correct supply voltage. The equipment must ALWAYS have an
adequate grounded (earth) connection. Electromagnetic fields may interfere with the operation of several
electrical and electronic devices such as pacemakers. We highly recommend people with such devices
to avoid using this kind of equipment.
PERSONAL CLOTHING
The entire body of the welder is subject to possible contact with aggressive agents and so must be totally
protected. Use safety boots, gloves, over sleeves, gaiters and leather aprons.
BURN PROTECTION
Never touch parts of the wire or the material with your bare hands once soldered. Avoid skin contact with
airborne particles. Do not point the torch/electrode at any part of the body.
EYE PROTECTION
Welders and their assistants must use safety masks or goggles with filters which stop harmful radiation
entering the eyes. Use special screens to observe the welding area during the process.
FIRE PROTECTION
The welding process produces flying incandescent metal parts which may cause fires. Do not use the
machine in areas where there may be inflammable gases. Clean the working area of all inflammable
material. Pay special attention to the protection of the gas cylinders in accordance with the necessary
requirements.
PROTECTION FOR GAS CYLINDERS
Cylinders containing shielding gas, store their contents at high pressure. If these cylinders suffer any
form of damage, they may explode. Always treat these cylinders with care and weld as far away from
them as possible. WELDING IN TANKS WHICH MAY CONTAIN THE TRACES OF INFLAMMABLE
MATERIALS INSIDE, INVOLVES A HIGH RISK OF EXPLOSION. WE RECOMMEND KEEPING AN
EXTINGUISHER READILY AVAILABLE FOR USE.
SOLTER SOLDADURA S.L.
11
Publicidad
