SIHOO V1 Manual De Usuario página 5

Step 6
Use 4 M6X25 screws to connect the backrest and armrests. Use a wrench to tighten them
clockwise to 80% tightness.
Step 7
J
Use 6 M6X35 screws to connect the seat cushion and armrests. Use a wrench to tighten
them clockwise while also tightening the screws connecting the backrest and armrest.
Step 8
Align the assembled upper part of the chair with the gas lift and insert it.
Step 9
Align the headrest with the holes on the upper part of the backrest, and use 2 M6X25
screws to install the headrest. Use a wrench to tighten them clockwise, and finally install
the headrest decorative cover.
03
I
The headrest can be
adjusted up and down,
as well as forward
and backward.
The lumbar support
can be adjusted up
and down.
To control the tilt, push
or pull the right-side
lifting rod of the base.
Height adjustment:
When sitting in the
chair, lift it to lower
the chair. When not
sitting in the chair,
lift it to raise the chair.
Safety Installation
P
1. Each chair is designed to support the weight of one person only.
2. Please use the chair on a flat, even surface.
I
3. Do not allow children under the age of 5 to sit on the chair without supervision.
4. Avoid sitting on the armrest to prevent potential accidents.
5. Do not stand on the chair, use it as a ladder, or step on it.
6. Please refrain from placing excessive weight on the chair or using it as a makeshift trolley.
7. Avoid using sharp or pointed objects that could damage the chair, and keep it away from
open flames or sources of heat.
8. For your safety, do not attempt to disassemble the gas lift mechanism.
Operation Instructions
(Please refer to the actual size.)
The armrests can
slide forward and
backward, as well
as rotate left and
right.
The rotating spring
knob adjusts the
reclining force.
The seat can rotate
360°.
04