RHINO RH-90711 Manual De Instrucciones página 12

Clamp start ac-
P79
tion angle
Shear line infeed
P80
in angle
Cut the line start
P81
angle
Retract angle cut
P82
line
Thick start angle
P84
thick end angle
P85
Encoder start
P92
angle
Loosen line
P101
starting angle
Loosen end
P102
angle
Release the
P117
presser foot
buffer delay time
(ms)
Oil alarm switch
P120
detects
Trimming needle
P121
selection mode
Timing off thread
P122
trimming de-
fence mode,
before trimming
back tack action
Cut the thread
P123
mode, trimming
back tack during
operation timing
Knee by inductor
P125
value AD 1
160- 270 The positioning angle of release
359
5-359 18 Shear line infeed is angle setting (under defi ned
as 0°)
5-359 140 Afterburner trimming angle setting
5-359 172 Afterburner trimming angle setting
0-330 9
0-330 57
160
1-359 30 Start angle for the loosening line (defi ned as 0°
under calculation)
1-359 180 Loose wire end angle (defi ned as 0° under cal-
culation)
0-990 12
0-1 0 0: Not Detected:
1: Detected
0-3 2 0: Normal mode
1: cut thread mode
2: off thread trimming defence mode
3: Reserved
0-1439 1000 A needle before the needle parameter values
greater the distance the greater the cut line
0-100 0
0-1023 25 Affects the lifter mechanism.
11