Publicidad
Idiomas disponibles
Idiomas disponibles
Getting started
Power
A
(on some models)
Press to "wake up" the display . If the display is active, press to put the dryer into idle mode .
NOTE: Pressing Power does not disconnect the appliance from the power supply .
Start and Pause
B
Press Start to begin the cycle . On some models pressing Start again will pause the cycle, the Start light will
blink and "Pause" will display . To continue the cycle, press Start again .
NOTE: The door must be closed for the dryer to start the cycle .
NOTE: Opening the door during operation will pause the dryer .
Display and Status Lights
C
The display shows the approximate time remaining until the end of the cycle .
In addition, this display will show the dryer status:
Pause
Controls
Sensing
Clean Lint Filter
Control Lock
D
You can lock the controls to prevent any selections from being made . Or you can lock the controls after you have
started a cycle . Children cannot accidentally start the dryer by touching buttons with this option selected .
To lock/unlock the dryer controls, press and hold the Extended Tumble and
seconds . The control lock icon will flash while locking/unlocking, stay on when locked, and turn off when
unlocked .
NOTE: The Power button can still be used when the machine is locked .
49-3000224 Rev 3
(on some models)
(on some models)
The Start/Pause light will flash and the message "Pause" will show in the display when
the dryer's cycle is paused . The cycle may be re-started by pressing the Start button .
The dryer is locked - will blink once if you press any button or turn the cycle knob .
Indicates the dryer is sensing the level of dampness to determine estimated cycle time
remaining .
The Clean Lint Filter light will stay on for 15 seconds after the cycle stops .
(on some models)
-
(minus) buttons for 3
7
Publicidad
