Publicidad
Idiomas disponibles
Idiomas disponibles
5. Carefully move t hewasher towithin 4feet(122cm) ofthe final
location.
6. Remove thefollowing f rom theback side ofthewasher:
3 bolt
3yellow plastic s pacers,
2 or3 metal "P"clamps.
9. Remove
thelarge styrofoam block located under thedrum. Liftup
onthedrum, tiltthebase o fthefoam block inwards toward the
rear o fthewasher until f ree, t henpull i tout.
10.Remove and discard theyellow ribbon and label from thefrontof
thewasher.
11.From therear o fthewasher, carefully pull o utthepower s upply
cordthrough
thehole inthebacksheet.
12. Replace theservice panel andscrews.
NOTE" If the washer is to be transported at a later date, the shipping
support hardware must be reinstalled to prevent shipping damage.
Retain the hardware in the pla .tic bag provided.
7. Remove the service panel from the front of the washer.
8. Remove the 4 nuts and 6 large washers that attach the 2 yellow
shipping braces to the drum and the base. Lift up on the drum
and remove the braces (a yellow ribbon surrounds the items to
be removed). These braces must be removed to allow the power
supply cord to be released from the shipping ring.
24 3/4
(62.9)
SIDE
ROUGH-IN
DIMENSIONS
_
60 _
|(152.4)
.,1
1
"_(2.54)
Power
Cord
33V2
(85)
24 3¼
(62.9) _
SIDE
._
60 _
(152.4)
(2.54)
Power
Cord
331/2
(85)
inch (cm)
Adjustable Legs
inch (cm)
Adjustable Legs
263/4
2¼
(7.3)
263A
(67.9)
2¼
(7.3)
36 1
(91.5)
Under
Counter
345/8
(87.9)
BACK
Water
Inlets
31s/8
(80.3)
36
(91.5)
Under
Counter
34%
(87.9)
Water
Inlets
315/8
(80.3)
UNDER COUNTER INSTALLATION
If an under counter* installation is desired, the washer MUST have a top sheet kit installed, P/N 131445600. Kit is availablefrom an
authorized parts distributor. *Custom sized countertop is required.
3
Publicidad
