Delta 23-196 Manual De Instrucciones página 10

ATTACH SPARK SHIELD AND EYE
SHIELD
1.
Using the provided M4 Hex Wrench, secure two M5 x
10mm hex screws with a M5 lock washer and flat washer
to secure spark shield
HP6
shield should be approximately 1/8 inch from the grinding
wheel.
2.
Repeat previous step for second spark shield.
3.
Use one M6 x 16mm carriage bolt
the outermost hole in the spark shield, to attach the eye
shield . Secure using one M6 flat washer
PC2
M6 lock washer
HP2
4.
Repeat previous step for second eye shield.
See Figure 1.
ATTACH TOOL REST
1.
Remove the knob
B
the carriage bolt on the lower portion of wheel guard.
Using the carriage bolt, lock washer, flat washer and
knob, attach the tool rest bracket
wheel guard as shown.
2.
Attach beveled tool rest support
support using one tool rest locking knob
3.
Adjust the position of the tool rest support so that the
tool rest is approximately 1/8 inch from the grinding
wheel .
A
4.
Repeat above steps for second tool rest.
See Figure 2.
ASSEMBLY
to the wheel guard. Spark
PC3
, inserted through
HP1
HP3
and an eye shield locking knob
, lock washer, and flat washer from
to the inside of the
PC7
to the tool rest
PC5
.
HP5
PC2
and one
.
HP4
PC5
10
Figure 1
A
PC7
Figure 2
PC3
HP5
B