AgfaPhoto Realishot VLG-4K Manual De Usuario página 8

EN
CHARGING THE TRIPOD
Connect the USB cable to the tripod, then to a
wall charger. During charging, the red indicator
light is flashing. The red indicator light keeps on
after the tripod is fully charged. (Charging time is
3-4 hours);
SUPPLY POWER TO THE CAMERA &
OTHER EQUIPMENT
Insert the larger end of USB cable to the Output
interface of the tripod, and connect the other
end to the camera or the device to be charged.
Turn on the power output switch of the tripod
(turn it to the ON position), the blue indicator light
will be on, which indicates the camera or device is
being charged.
Note: The same USB cable cannot be connected
to the output and input ports of the tripod at the
same time.
REMOTE CONTROL
Functions: The remote control can be taken out
from the tripod. Press the M Button to rotate the
display. Hold and press the M Button, the camera
turns to video or photo mode. Press the W/T
Button to zoom, press Focus Button to focus.
Press the OK button to take a photo or Video.
The effective distance of the remote control
is within 10 meters. (The camera needs to be
installed with a memory card and powered on
before being remotely controlled.)
Battery replacement : When the remote control
battery is ran out (the button light is not bright
enough or not bright), remove the screws on the
back of the remote control, remove the battery
cover, and take out the battery. Insert the new
battery with the negative side facing down, and
put the battery cover back.
8
SPECIFICATIONS
NAME
Tripod Vertical
Adjustment Angle
Tripod Horizontal
Adjustment Angle
Tripod Battery
Input Voltage
Input Current
Output Voltage
Output Current
Tripod Charging Time
Tripod Size
Tripod Load-bearing
Tripod Weight
Remote Control
Distance
Remote Control
Battery
PARAMETERS
About 135°
360°
3.7V 2500mAh
5V(Micro)
1A
5V+/-0.3
5V/1A
3-4 Hours
H200*T46(Head)*
W40mm
Within 1KG
About 195G
Within 10 meters
3V CR2032