Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Safety
EN
Safety
• These instructions are for your safety.
Please read through them thoroughly prior
to installation and retain them for future
reference.
• All fittings must be installed by a competent
person in accordance with local regulations
(IET wiring regulation BS7671).
• Check the pack and make sure you have all
of the parts listed.
• Remove all packaging, wrap etc from the
product.
• Decide on the appropriate location for your
product.
CAUTION: IP43 is guaranteed when
the product is properly installed
and sealed.
• The product must be securely fixed to the
mounting surface using the anchor bolts
supplied. The anchor bolts supplied are
suitable for masonry or concrete only.
Other fixings not supplied and must be
purchased.
• Take care not to drill into any pipes or
mains cables beneath the surface during
mounting holes preparation.
IMPORTANT: The fixing point(s)
selected must be capable of supporting
the full weight of the light fitting.
• We recommend connecting this product
to an external / wall switch in order to
deactivate the motion detection function if
necessary.
• Wiring diagram is for reference only. Always
refer to the terminal marking for wiring.
Ensure that all electrical connections are
tight and that no loose strands are left out
of the terminal block.
• When the product does not light after
installation:
> Ensure there is no electricity failure
> Ensure all the connections are secured
216383_s1_s57-5059340231648-Blooma-A5-IM-V02.indb 2
216383_s1_s57-5059340231648-Blooma-A5-IM-V02.indb 2
• If you have any doubt about installation/
use of this product, consult a qualified
electrician.
• It is recommended to have a regular
schedule of care and maintenance to keep
the surface condition well.
Technical data
Supply
220-240 V , 50/60 Hz
voltage:
1000 W for incandescent;
Max.
switching
300 W for fluorescent;
capacity:
150 W for LED (Max. 6 pcs)
This product complies with
conformity requirements of the
applicable European Regulations
or Directives.
IP43
Rain-proof
Waste electrical products should
not be disposed of with household
waste. Please recycle where
facilities exist. Check with your
Local Authority or local store for
recycling advice.
Do not use with a dimmer switch.
xxWyy
xx-year; yy-week of the year.
2
10/15/21 10:35 AM
10/15/21 10:35 AM
Publicidad
