TEFAL PREP'MIX+ Manual Del Usuario página 14

Dear customer, thank you for choosing our hand mixer, Prep'Mix+! Please find here all the
EN
information you may need about its use. We hope you will enjoy it!
N.B.: A booklet containing safety guidelines is provided with this appliance.
Before using your appliance for the first time, please read the booklet carefully and keep it in a safe
place.
Before use, remove all accessories from their packaging and clean them using hot water and
a little washing up liquid, except moto unit (A). Rinse well and dry thoroughly.
FIRST USE
USING HAND MIXER
• Check that the speed control (A2) is set to "0".
• Insert the rod of each beater (B) or kneader (D) into the corresponding holes and lock
into place until "click". The beaters and kneaders have a specific shape, the kneader
or beater with the beater marker (C) should be positioned to the right, in the
biggest hole.
• Connect the appliance:
– Your appliance has five speed levels and a Turbo button. Always begin mixing or kneading
at setting 1 initially, then move to setting 2, 3, 4 or 5.
• After finishing, set the speed control (A2) to "0".
• Disconnect.
• Then press the ejection button (A1) to remove the beaters or mixers.
USING THE BASE (L) (ACCORDING TO MODEL)
• Place the base (H) on the worktop.
• To raise the arm, unlock by pressing on the button (M)
• Position the bowl (K)
• Press on button (M) to unlock the arm and lower it
• Place the mixer (A), fitted with kneaders (F) or beaters (E), on the hinged arm until you hear
it click into place The beaters and kneaders have a specific shape, the kneader or beater with
the beater marker (G) should be positioned to the right, in the biggest hole.
• Connect the appliance as instructions above using hand mixer
• After finishing, set the speed control (A2) to "0".
• Disconnect and press the unlock button (M) to raise the hinged arm. Then press the mixer
unlock button to remove the mixer from its stand.
• Then press the ejection button (A1) to remove the beaters or kneaders.
USING THE HANDBLENDER FOOT (H OU I) (ACCORDING TO MODEL)
Check that the speed control (A2) is set to "0".
• Remove the panel at the back of the appliance (A) and screw the handblender foot (H or I)
by turning clockwise without forcing it, until you will hear a small click, the rod is correctly
positioned (Fig. 12 and 13).
• Connect the appliance:
– Dip the Mixer rod in the preparation before starting to avoid splashing.
– Start using the Eject button
– Stop the appliance before removing from the Blender rod (to avoid splashes).