Publicidad
TRANSPOSE UP/TIE/TRIPLET - this is used to transpose
(32)
the octave upwards in PITCH MODE, enter a tie in TIME
MODE, and set the pattern to triplet mode.
ACCENT / PATTERN A - this allows an accent to be added
(33)
to notes in PITCH MODE, and to select "A" patterns such as
1A, 2A, to 8A.
SLIDE / PATTERN B - this allows a SLIDE to be added to
(34)
notes in PITCH MODE, and to select "B" patterns, such as
1B, 2B, to 8B.
D.S./WRITE/NEXT/TAP - this allows a pattern to be
(35)
written to a track, to select the next note in a pattern,
and to add manual timing by tapping. This switch
and BACK (27) are used to view and change SYNC and
CLOCK settings.
Rear Panel
OUTPUT - connect this 1/4" TS output to the line-level
(36)
audio input of your system. Make sure the volume
is turned down and the system is turned off before
making connections.
MIDI OUT/THRU - this 5-pin DIN jack is used to output
(37)
MIDI OUT data, and pass through MIDI data received at
the MIDI INPUT.
MIDI IN - this 5-pin DIN jack receives MIDI data from an
(38)
external source. This will commonly be a MIDI keyboard,
an external hardware sequencer, a computer equipped
with a MIDI interface, etc.
USB PORT - this USB type B jack allows connection
(39)
to a computer. The TD-3 will show up as a class-compliant
USB MIDI device, capable of supporting MIDI in and out.
USB MIDI IN - accepts incoming MIDI data
from an application.
USB MIDI OUT - sends MIDI data to an application.
POWER - turn the synthesizer on or off. Make sure all the
(40)
connections are made before turning on the unit.
DC INPUT - connect the supplied 9V DC power adapter
(41)
here. The power adapter can be plugged into an AC outlet
capable of supplying from 100V to 240V at 50 Hz/60 Hz.
Use only the power adapter supplied.
21
Quick Start Guide
Publicidad
