Melchioni Family CUBIK Manual De Instrucciones página 13

Compressor malfunctions with
1 hum
The lack of water indicator is on
2
The indicators on the display
3
are not lit.
The ice produced is too large
4 and with pieces sticking
together
The ice making process was
5 fine, but no ice came out
All indicators flash at the same
time
6
The machine worked, but the
7 water got hot
When the ice cube tray is full,
the machine does not display
8
the ICE FULL icon
CONFORMITY OF THE PRODUCT
The producer Melchioni Ready S.r.l. declares that the product Ice maker CUBIK, cod. 118700201, is in compliance with
Directive 2014/30/EU of the European Parliament and of the Council, of 26 february 2014, on the harmonisation of the
laws of the Member States relating to electromagnetic compatibility.
The producer Melchioni Ready Srl declares that the product Ice maker CUBIK, cod. 118700201, is in compliance with
Directive 2014/35/EU of the European Parliament and of the Council, of 26 february 2014, on the harmonisation of the
laws of the Member States relating to the making available on the market of electrical equipment designed for use
within certain voltage limits.
The producer Melchioni Ready Srl declares that the product Ice maker CUBIK, cod. 118700201, is in compliance with
Directive 2009/125/EC of the European Parliament and of the Council, of 21 october 2009, establishing a framework
for the setting of ecodesign requirements for energy-related products.
The producer Melchioni Ready Srl declares that the product Ice maker CUBIK, cod. 118700201, is in compliance with
Directive 2011/65/EU of the European Parliament and of the Council, of 8 june 2011 and subsequent Commission
Delegated Directive 2015/863, on the restriction of the use of certain hazardous substances in electrical and electronic
equipment.
According to Directive 2012/19/EU of the European Parliament and of the Council, of 4 july 2012, on waste electrical
and electronic equipment (WEEE), the presence of the crossed-out bin symbol
to be considered as urban waste: its disposal must therefore be carried out by separate collection. Disposal in a non-
separate manner may constitute a potential harm to the environment and health. This product can be returned to the
distributor when purchasing a new device. Improper disposal of the appliance constitutes misconduct and is subject to
sanctions by the Public Security Authority. For further information, contact the local administration responsible for
environmental matter.
The voltage is lower than recommended
1. There is no water
2. The pump is filled with air
Blown fuse /
No power
There is ice left in the tray from previous
cycles
1. The compressor has no refrigerant
2. Compressor damaged
3. Fan motor damaged
1. The water tray is blocked by an ice
cube
2. The engine is stuck, or the engine
comes off or the engine is damaged
3. Micro switch damaged
The solenoid broke
1. Full ice sensor damaged
2. Interference from sunlight
12
Stop the ice maker and do not
restart it until the voltage is
adequate
1.Add a little water until
reaching the MAX position
2.Press the POWER button to
restart
Replace the fuse /
Turn on the power
In standby mode, remove the
ice
Contact the technical
assistance service
1. Disconnect the power to
take out the ice blocking the
tray, then connect the power
and press the POWER button,
the machine will restart 3
minutes later.
2. Contact the technical
assistance service
1. Replace the solenoid valve
2. Contact the technical
assistance service
1. Replace the full ice sensor
2. Make ice inside
3. Contact the technical
assistance service
indicates that this appliance is not