Publicidad
Idiomas disponibles
Idiomas disponibles
SETUP - BEFORE USE
Read the ENTIRE IMPORTANT SAFETY
INFORMATION section at the beginning of this
manual including all text under subheadings therein
before set up or use of this product.
WARNING
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug
the tool from its electrical outlet before performing
any procedure in this section.
Note: For additional information regarding the parts listed
in the following pages, refer to the Assembly Diagram
near the end of this manual.
Mounting
Secure the tool to a supporting structure before use.
Before assembly, bolt the Base to a flat, level, solid
workbench capable of supporting the weight of the drill
press and any workpieces.
Verify that installation surface has no hidden utility lines
before drilling or driving screws.
Assembly
Column to Base
1. Loosen Set Screw (9) in Rack Collar (78) and remove
Rack Collar and Gear Rack (92) from the Column (101).
The Gear Rack is stowed in this position only for transit
purposes.
2. Place Column Base (93) on the Base (94) and align
the holes in the Column Base with holes in Base.
3. Attach using Bolt (102) in each hole through
the Column and into the Base.
Base (94)
Table to Column
1. Assemble Worm Gear (84) and Lock Handle (81)
to the Table Support (82). Do not tighten down
the Lock Handle at this time.
2. With the longer smooth end of Gear Rack (92)
uppermost, place Gear Rack into notch of Table
Support opening, making sure Gear Rack meshes with
teeth of Inner Gear (83).
Column (101)
Bolt (102)
Column base (93)
3. Assemble the Table (87) to the Table Support with
the Angle Bolt (88).
Table support (82)
Table (87)
Table support
(82)
4. While holding Gear Rack and Table Support as
assembled, slide both down onto the Column until
Gear Rack bottom is positioned against Column Base.
5. Replace Rack Collar, beveled side down, onto Column
and top of Gear Rack. Tighten Set Screw.
Note: Ensure that Gear Rack is not pinched. Gear Rack
should move freely when Table is rotated around Column.
6. Assemble the Lift
Handle (85) to
the end of
the Worm Gear
shaft and secure
it in place with
the Set Screw.
Note: Confirm
the Set Screw
engages
the flat surface
of the Worm
Gear shaft.
3
Worm gear (84)
Lock handle (81)
Gear rack
(92)
Set screw
Rack collar
(9)
Lift handle
Set screw
(9)
Gear rack
Column
Column base
(101)
(93)
(78)
(85)
(92)
Publicidad
