Publicidad
Idiomas disponibles
Idiomas disponibles
SETUP - BEFORE USE
Head Assembly to Column
1. Loosen the Set
Screw (32) on each
side of the Head
Assembly so they
will stay clear while
installing it.
2. With assistance, lift
the Head Assembly
above the Column, and
gently slide it down
the Column as far
as it will go. Make sure
the Head Assembly
slides completely onto
the Column.
3. Align the Head Assembly
with the Base, and tighten
the two Set Screws to secure
the Head Assembly in place.
Feed Handles/Bars
1. Thread the Feed
Handle Bars (27)
into the Feed
Bar Seat (44) and
tighten them.
2. Thread the Feed
Handle Knobs (26)
onto the Feed
Handle Bars and
tighten them.
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT SAFETY
INFORMATION section at the beginning of this
manual including all text under subheadings therein
before set up or use of this product.
TOOL SET UP
WARNING
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug
the tool from its electrical outlet before performing
any procedure in this section.
TO PREVENT SERIOUS INJURY:
DO NOT OPERATE WITH ANY GUARD DISABLED,
DAMAGED, OR REMOVED. Moving guards must
move freely and close instantly.
Head assembly
Set
screw
(32)
Feed bar seat
(44)
Feed handle bar
(27)
Feed Handle
Installing/Removing the Chuck
1. Loosen the Lock Handle and slide the Table up
the Column to within 6" of the Spindle (71).
Tighten the Lock Handle.
2. Open the jaws of the Chuck (76) to their maximum,
using the supplied Chuck Key.
3. Put a piece of scrap wood on the table to protect
the Chuck nose.
4. Ensuring all parts are thoroughly clean, dry and burr free,
place the Chuck with its open jaws on the scrap wood,
directly under the Spindle.
5. Use the Feed Handle to gently lower the Spindle so
it is just entering the opening in the top of the Chuck.
6. Examine the Chuck from all sides to be sure that
it is properly aligned with the Spindle.
7. Using the Feed Handles, insert the Spindle all the way
into the Chuck, pressing the Chuck nose hard against
the piece of scrap wood on the Table to secure
the Chuck into place.
Knob (26)
Table Adjustment
1. Adjust the Table (87) by loosening the Lock Handle (81),
moving the Table, and tightening the Lock Handle.
2. Tilt the Table by removing the Locator Pin (20),
loosening the Angle Bolt (88) and tilting to the required
angle. The angle can be read using the Angle Scale (72).
When returning Table to zero degrees (horizontal),
re-insert Locator Pin and tighten Angle Bolt.
3. TO ENSURE THAT THE DRILL IS ENTIRELY
PERPENDICULAR TO THE TABLE, insert a straight
round bar (not included) in the Chuck (76), place a
square on the Table and bring it up to the round bar.
Adjust the angle as needed.
4
Chuck
(76)
Table
Publicidad
