GE 23 Manual Del Propietario E Instalación página 23

Installation Instructions
[] PUT THE REFRIGERATOR
IN PLACE
Move the refrigerator to its final location.
151LEVEL THE REFRIGERATOR
The refrigerator can be leveled by
adjusting the rollers located near the
bottom hinges.
Rollers have three purposes:
Raise
Rollers adjust so the door closes easily
when opened about halfway. (Raise the
front about 5/8" [16 mm] from the floor.)
Rollers adjust so the refrigerator is
firmly positioned on the floor and does
not wobble.
Rollers allow you to move the
refrigerator away from the wall for
cleaning.
To adjust the rollers:
• Turn the roller
adjusting screws
clockwise to raise
the refrigerator,
counterclockwise
to lower it. Use
a 3/8" hex socket
or wrench,
or an adjustable
wrench.
Roller adjusting screw
[] LEVEL THE DOORS
Adjust the refrigerator door to make the
doors even at the top.
[]
To align:
Using a 7/16" wrench, turn the door
adjusting screw to the right to raise the
door, to the left to lower it.
NOTE:
A nylon plug, imbedded in the threads
of the pin, prevents the pin from turning
unless a wrench is used.
After one or two turns of the wrench,
open and close the refrigerator door and
check the alignment at the top of the doors.
Doors should be even at top
171SCREW DOWN SUPPORT LEG
Screw down the support leg until it
touches the floor. This will prevent door
misalignment.
23