Magmaweld ECO Serie Manual Del Usuario página 22

22 Operation
3.2 Connection to Mains
Check the mains voltage before connecting
EN
the machine to the mains.
• Start the machine with the on/off switch.
• Turn the machine off by turning the on / off switch back to off after hearing the fan noise and seeing the mains
lamp is illuminated.
3.3 Placing The Wire Spool And Wire Feeding Process
• Unscrew the screw of the wire transport system by turning it. Slide the welding wire roller onto the wire
carrier system shaft and re-tighten the screw.
b
a
• Pull and lower the pressure screw on the wire feed roller, which means bring the pressure rollers to idle
Figure 4 : Placement of Wire Spool
position.
If the end of the wire is missed, the wire can jump like a spring and damage you and others.
• Pass the wire through the wire entry slot without releasing the wire into the rollers and into the torch
through the rollers.
Figure 5 : Feeding the Wire to Rollers
USER MANUAL
c
Tightening the screw of the wire transport system prevents the
wire from being fed and may cause failures. If the screw has not been
tightened adequately this can cause the wire spool to empty
after a period of time when the wire feed has stopped. For this
reason, do not connect the screw too tightly or too loosely.
• Find and open the welding wire end from the wire spool and cut off the end with
a side chisel.
When inserting the plug into the mains
socket, ensure that on/off switch is in the "O"
position.
ECO SERIES
www.magmaweld.com