PURLINE VENTY ARGENTUM Manual De Instrucciones página 16

EN
OPERATION
The voltage of the power source must comply with the details on the type plate of the appliance.
Always operate the fan in the upright position following all instructions and recommendations
listed in this manual.
USING THE REMOTE CONTROL
1. Place 2 AAA size batteries (not included) in
the remote control.
2. The sensor of the remote control must be
pointed at the fan receiver to operate properly.
3. The distance between the remote control
and the fan should be within 6 meters an 30
degrees radius left to right of the fan.
4. See the button functions as they appear on
the remote control. (Fig.4)
ON/SPEED
Press this button, the fan will start to operate at low speed if it is the first time you have plugged
it in. If the fan was plugged in before, it will start to operate at the speed it was at when last
turned off.
1. After starting the fan ,this button is for setting the speed. Press this button repeatedly and
you can choose from "LO-MED-HI" and back to "LO" speed in that sequence.
TIMER
Accessed using the remote control, the timer function is designed to work during oscillation or
any fan mode or speed. Press the TIMER button, each time it is pressed, time duration indicator
lights illuminate. (0.5, 1, 2 or 4 hours). Simply add up the time value of the lights to see timer
setting up to 7.5 hours maximum time. To turn the timer function off, press the TIME button
continuously until all the timer indicator lights are off.
SWING
again if you want to keep the fan operating in one position. The fan will only oscillate once the
SWING button has been pressed.
16
Fig. 4