Autool SDT205S Manual De Instruccion página 12

Instruction of
smoke leak
detector
pressure
gauge
Airbag
adapter
instructions
The smoke leak detector pressure gauge has two main
●
functions, one is for machine self-test, and the other is used for
leak judgment, which can be used to initially determine the
leakage of piping system through the change of pressure
gauge pointer. If the pointer of the pressure gauge keeps still,
which represents there is a relatively serious leak in the
pipeline; the pressure gauge pointer will rise to a fixed
pressure value only if the area of the piping system currently
being tested is relatively small. And if there is a leak, the
pressure gauge pointer will drop or become unstable. In this
case, you can turn on the smoke switch to output smoke to
locate the leak.
Airbag adapters are suitable for non-circular connections. While
for round and oval ports, please use the inlet tapered adapter for
normal cases.
●
Before using the airbag adapter, be sure to clean the inner wall
of the intake manifold (or other test interfaces) to prevent sharp
protrusions from piercing the airbag adapter.
●
Put the air bag (Z) into the test port.
●
Press the hand pump (X) until the bladder (Z) inflates and fully
seals the test port.
● Connect the cone head on the smoke outlet pipe with the
smoke guide pipe (Y), introduce gases and smoke into the duct
to be tested.
After the test is completed, turn the pressure relief valve (W)
●
counter clockwise, take out the car air inlet adapter from the
test port, clean and save it.
NOTE
Airbag adopter can not contact with corrosive oil.
7