Autool SDT205S Manual De Instruccion página 7

PRODUCT INTRODUCTION
Overview
Working
theory
Features
AUTOOL SDT205S is an integrated automotive smoke detector
made of aluminum alloy. It is designed with clear pressure gauge
for easy detection of pipeline leaks. Moreover, it comes with two
test modes: i.e. Air mode and smoke mode. With the help of air
mode, it is possible to diagnose whether there is a leak through
the pressure gauge with no need to output smoke. As for smoke
mode, it is equipped with an independently controlled smoke
generator. This mode can be activated in case a leak is found,
enabling you to locate the leak precisely. Moreover, a visible flow
meter can effectively observe and control the flow rate of the
smoke output, while a visible pressure gauge can accurately
determine if the pipe is leaking.
AUTOOL SDT205S is suitable for all pipes of cars, motorcycles,
snowmobiles, off-road vehicles, dune buggies, light trucks, and
speedboats. It's recommended to use an automobile diagnosis
tool to work with SDT205S to detect car engine problems more
quickly.
Low oxygen combustion
●
The AUTOOL smoke leak detector employs a forced combus-
tion smoke generation method in a low oxygen environment. It
is energized by a conductive column to the heating wire, which
rapidly heats up to more than 300°C so that the mineral oil
reaches the ignition point and enters the state of combustion.
Due to the small intake of air flow, it is insufficient to provide
sufficient oxygen to maintain full combustion, thus the combus-
tion mainly occurs on the surface of the heating wire. Subject
to high-temperature heating, the mineral oil retention object
can continue to burn insufficiently around the heating wire,
thus producing a large amount of smoke.
Built-in Air Pump
Overheat Protection
2
Yes
Yes