Zizito EGON Manual Del Usuario página 10

EN
3. FIXING THE FEET
Turn the highchair upside down. Please note that each of the four legs has a sprung
loaded pin. Line up one of the feet so that the small hole in the top of the foot lines up
with the pin. Push firmly on the foot at either end until each of the two sprung pins click
into place within the small hole in the foot. Repeat for other foot. Note the rear foot has 2
insert wheels inside. Take one stop washer and insert the short screw, then insert it into
the bottom hole at the rear of the front left leg and repeat the process on the right leg.
10
2. ASSEMBLY
Take either the left or right leg (4),
press and hold down the red button (a)
and extend the leg then release the
red button.
Take the other leg and follow the
above procedure. Take the legs and
nothing the orientation in the diagram
insert the legs into the top of the seat
until adjusting brackets. To lift the seat
unit to the top of the legs simply press
and hold the red buttons to the seat
unit adjustment brackets and lift. There
are six positions to adjust height.