AMiO FY-004 Instruccion De Uso

EN
EN - USER MANUAL
Car Air compressor 12V mini FY-004
The compressor is designed to pump tyres, balls, beach
toys, mattresses, etc. It is equipped with a set of terminals
and a 12 V power plug.
SAFETY INSTRUCTIONS:
• do not use the compressor on snow and rain
• do not use near flammable gases or liquids
• keep the device in a dry, closed place, do not allow
children to use it
• do not overload the device, damage caused by overload
is not covered by the warranty
• check the condition of the supply and compressed air
line before each use
• keep it clean
• disconnect the device from the power supply when not
in use
• do not use damaged or leaking objects for pumping
• do not connect to circuits protected by a smaller fuse
than 15 A
• do not use the device with the engine turned off
for more than a few minutes, prolonged use of the
compressor may discharge the battery in the car.
PREVENTING MALFUNCTIONS:
Keep the contacts of the compressor plug clean, dirty
contacts can cause malfunction of the compressor and
overheating of the plug.
Do not overload the device, the maximum continuous
operation time is 10 minutes.
USE:
• check what pressure is appropriate for the item being
filled - never exceed the maximum values!
• place the compressor on a stable surface, outside the
car, do not use it inside the car.
• start the car engine, this will speed up the compressor
and protect the battery from discharge.
• plug the compressed air hose into the object, plug the
power cord into the socket.
• fill the item with the required air pressure.
Never leave the unit unattended.
Disconnect the device from the power supply when you
have finished working with the compressor.
CAUTION!
The compressor is not for commercial use. It can operate
for up to 10 minutes, after that time, unplug it from the
power supply and wait at least 10 minutes for it to cool
down. Prolonged use may cause the compressor to
overheat and seize.
When the compressor is used to inflate tyres in motor
vehicles, take an additional measurement with an
approved pressure gauge, the values indicated on the
built-in pressure gauge are indicative.
IN CASE THE COMPRESSOR STOPS WORKING:
• check the power cord for damage
• check that the contacts of the plug and socket are not
dirty
• check that the fuse of the socket outlet has not blown
out (for proper operation of the compressor, the outlet
should be protected with a minimum fuse of 15 A)
TECHNICAL PARAMETERS:
• input voltage: DC 12V
• maximum pressure: 20 bar / 300PSI
• power supply cable length: 3m
• hose length: 40cm
DECLARATION OF CONFORMITY
Product model/SEE identifier: FY-004/02189
Name and address of the manufacturer Amio Sp. z o.o.
ul. Handlowa 3, 41 - 807 Zabrze
This declaration of conformity is issued under the sole
responsibility of the manufacturer.
Subject of the declaration:
Name: Car Air compressor 12V Acomp-14
Serial No.: FY-004/02189
Year of manufacture: 2023
The above mentioned product complies with the
following directives
EMC 2014/30/UE norms:
EN IEC 55014-1:2021, EN IEC 55014-2:2021
The EC market test was carried out by: Shenzhen CTB
Testing Technology CO., LTD., Floor 1,2 Building A, No.26
of Xinqiao Community, Xinqiao Street Baoan District,
Shenzhen, Guangdong, CHINA.
Other information: Manufactured in PRC for Amio Sp. z
o.o., 3 Handlowa St., 41 - 807 Zabrze
The declaration of conformity is kept at the company's
headquarters: Amio Sp. z o.o. 3 Handlowa street, 41-807
Zabrze.
President of the Board
Grzegorz Dudziak
Zabrze, 2023 r.
ENVIRONMENTAL PROTECTION
This marking shown on the product and its literature
indicates this kind of product mustn't be disposed
with household wastes at the end of its working life
in order to prevent possible harm to the environment
or human health. Therefore the customers is invited to
supply to the correct disposal, differentiating this product
from other types of refusals and recycle it in responsible
way, in order to re - use this components. The customer
therefore is invited to contact the local supplier office for
the relative information to the differentiated collection
and the recycling of this type of product.
02189
P/N:
1