Mx Onda MX-AS2048 Manual De Instrucciones página 29

Charging the battery
Caution!
Before mounting, make sure that you will not damage any pipelines. Find out exactly where the
pipelines are.
You can choose if you want to charge the device on the wall holder, or if you want to charge the
device directly with the net adaptor (without the wall holder).
1. If you want to use the wall holder, place the device in the holder, with the collection container
facing up.
2. If you do not use the wall holder, place the jack plug of the net adaptor into the connection
socket on the backside of the vacuum cleaner.
3. Then connect the net adaptor with a 230V-50Hz socket.
4. The red control lamp signals the correct connection of the power plug with the vacuum cleaner
and also that the vacuum cleaner is being charged. After about 12 hours the battery of the
vacuum cleaner is fully charged.
Caution!
Please use the supplied net adaptor only, or another one with the same technical data, otherwise
the device may become damaged. In order to achieve the maximal charging capacity of the battery,
before the first use charge the device fully. The first charging cycle takes 12 hours.
During the actions described above, you should disconnect the power plug from the socket after
charging the battery for 12 hours, in order not to overload it.
Starting operation with the ON/OFF button
1. Before each use you should empty the collection container and clean it.
2. To switch the device on, move the ON/OFF switch forwards.
The device begins operation.
3. In order to switch the device off, move the ON/OFF switch backwards.
The device switches off.
5