Makita DMR200 Manual De Instrucciones página 6

Power
The speaker can be powered by Makita battery packs or a
standard wall outlet.
Power by battery
The following table indicates the operating time on a single charge.
Battery
capacity 10.8V
-12Vmax
1.3Ah
BL1016
1.5Ah
BL1021B
2.0Ah
3.0Ah
BL1041B
4.0Ah
5.0Ah
6.0Ah
Installing or removing slide battery
4)
To install the battery cartridge, align the tongue on
•
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way until it
locks in place with a little click.
• If you can see the red indicator on the upper side of
the button, it is not locked completely. Install it fully
until the red indicator cannot be seen. If not, it may
accidentally fall out of the tool, causing injury to you or
someone around you.
• Do not use force when inserting the battery cartridge.
If the cartridge does not slide in easily, it is not being
inserted correctly.
• To remove the battery cartridge, sliding it from the tool
while pressing the button on the front of the cartridge.
Note:
When the speaker is in low battery, the middle LED
will flash in red.
5
Battery Cartridge Voltage
14.4V
BL1415
BL1415N
BL1430/
BL1430B
BL1440
BL1450
BL1460B
AT SPEAKER OUTPUT = 100mW (unit: Hour)
18V AUX IN
BL1815 7.5
12
10
BL1815N 9.5
15
BL1820/
13
BL1820B
16
BL1830/
18
BL1830B
31
26
BL1840/
25
BL1840B
31
BL1850/
32
BL1850B
34
BL1860B 39
Indicating the remaining battery
capacity
Only for battery cartridges with "B" at the end of the
model number
(Approximately)
AUX IN
Bluetooth
+USB(2.1A)
7.0
11
9.0
9.0
14
12
15
17
28
24
24
29
31
32
37
1
Bluetooth
+USB(2.1A)
1.0
1.0
1.0
1.5
1.0
2.0
2.0
3.0
2.5
3.0
4.0
3.5
5.5
4.0
6.5
2