Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING THE FILTER
Press the release button to
completely remove the dustbin.
Remove the filter from the top. Rinse
the filter with water and ensure it is
completely dry before reassembling.
It is recommended you rinse your
filter every 3 months.
ASSEMBLING THE WALL MOUNT
Choose a hard wall surface. Drill a
pilot hole in the wall, align the wall
mount, insert the screw into the
drilled hole and tighten.
STORAGE
It is recommend to place the Wall
Mount & Dual charger 120 cm
(47.25") above from the ground.
NOTE:Do not let the power cord pass
through sharp objects, and avoid
dragging the power cord to move the
machine to prevent damage to the
power cord.
CHARGING
Battery pack:
1.During charging:
Three white lights will flash.
2.After charging is completed, 3
white lights will be on for 1 min, and
10
then go out.
Wall Mount & Dual charger :
The white light flashes during charg-
ing. When fully charged, the green
light illuminates for 1 minute and
then will go out.
NOTE:The Wall Mount & Dual charger
and the Adapter need to be used
together.
Do not operate the vacuum cleaner
while charging.
Place the Vacuum Cleaner on the
Wall Mount.
It is recommend to place the Wall
Mount 80 cm (31.5") above the
ground.
NOTE: If you need to charge, please
plug the battery pack into the
Charger.
6.MAINTENANCE
WARNING: Remove the battery before carrying out
any servicing or maintenance.
Never use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth. Always
20V Cordless Stick Vacuum Cleaner
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls
free of debris. If you see some sparks flashing in the
ventilation slots, this is normal and will not damage
See Fig. E4
your power tool.
Operation instructions for the accessories
Included accessories can be attached to clean
upholstery, stairs, cars and more.
Precautions when using the machine
See Fig.
Cannot be used to absorb water.
F1, F3
Cannot be washed in water.
When cleaning or maintaining, remove the battery
pack.
The product is intended for use on flat surfaces in
indoor environments, and may not achieve optimal
results if used on uneven surfaces.
Do not get the body of the machine wet, as this may
See Fig. F1
cause a short circuit and result in fire or electric
shock.
FOR BATTERY TOOLS
The ambient temperature range for tool and battery
use and storage is 32
The recommended ambient temperature range for
the charging system during charging is 32
(0
C-40
o
7.TROUBLESHOOTING
See Fig. F2
Issue
Motor does
not operate.
See Fig.
Decreased
F3, G
suction
Machine
heating
F-113
F (0
O
O
C).
o
Causes
The Battery
Pack is not
installed.
The battery
has run out.
Dust cup is full
of debris.
The filter of the
dustbin is full
of debris.
Battery low
Machine run
C-45
C).
o
o
F-104
F
o
o
Solution
Check
whether the
battery pack
is installed
correctly.
Charge the
machine or the
Battery Pack.
Clean the
dustbin.
Clean or
replace filter
element of
dustbin.
Charge the
machine or the
Battery Pack.
Slight heating-
up is normal.
EN
Publicidad
