Publicidad
Idiomas disponibles
Idiomas disponibles
Package contents
Please check the contents to ensure that the product has been received in good Condition.
1 pc FS-HAZER-01 Hazer Machine
1 pc User Manual
1 pc Power cord
1 pc Remote control
If you find any accessory is missing or the machine has arrived with any problems, please contact your local dealer at
once. Do not try to fix this item yourself or you will lose the warranty. Please keep the original package and invoice for
any possible replacement or returned demand.
Recommended fluid
For the FS-HAZER-01 haze machine we strongly recommend the following Triron-Blue heavy fog fluid which has been
specifically formulated to perform best with any heater based haze machines. To guarantee trouble-free operation the
special "Hazer fluid Triton-Blue" must be used. Use of other liquids will void the manufacturer's warranty and can be
dangerous to your health.
Setup
1. Unpack the haze machine
2. Unscrew the top cap of the tank and remove to fill with the recommended haze fluid
3. Replace the bottle and screw the cap securely ensuring the pipe is fed down to the bottom of the bottle so a
consistent flow of fluid is supplied to the machine
4. Connect the remote control
5. Connect the IEC mains plug and power up
6. Heat up time is usually between 2-3 minutes. Please ensure no button is pressed during the heat up time. When the
machine is ready the LED light on the machine and remote control will illuminate
7. After heat up, please refer to page 5"Operation for LF-2"
CAUTION! TO PREVENT MORTAL ELECTRICAL RISK AND LONG LIFE OPERATION. For your safety, please
kindly pay attention to all of the warnings listed below:
1. Always plug in the power plug last and disconnect from the mains when the device is not in use or before cleaning
2. Do not install and operate the device in rain or extreme heat, moisture or dusty environments
3. This device is for indoor use only and in a dry environment
4. Do not switch on immediately but wait until it reaches to room temperature if the device has been exposed to drastic
temperature fluctuations
5. Do not shake the device and avoid brute force when installing or operating
6. Do not use the device during thunderstorms and please disconnect the power
7. Do not use solvents or aggressive detergent to clean the device. Use a soft and clean cloth
8. Do not modify the device or the connected power cord without authorisation
Connect with power supply. The ground wire must be connected. Use the plug to connect to the main power supply as
follows: Live (Brown cable), Neutral (Blue cable), Earth (Yellow/Green cable).
If the unit is not functioning properly
1. Check if main power is on.
2. Check the fuse hasn't blown.
3. Check the unit isn't in DMX mode.
4. Check there is fluid in the tank and the pipe is pushed down to the bottom of the bottle
5. If there is blockage use distilled water or haze machine cleaning fluid
User manual MAQUINA DE NIEBLA-HAZE MACHINE | Rev. May 2014
Publicidad
