Publicidad
Idiomas disponibles
Idiomas disponibles
F (Fan Speed) and h (Haze Output) are settings for continuous stand-alone operation and will override any remote
control of the FS-HAZER-01
When in DMX mode there are two channels with the following function:
DMX channel
CH1
CH2
Timmer controller
The timer controller can be used to control the FS-HAZER-01 remotely. Please note Fan Speed (F) and Haze Output
(h) must be set to zero for the remote timer controller to operate.
1. Timer on/off button
2. Continuous output
3. Manual override button
4. Timer LED indicator (Illuminated Yellow when timer active) 5. Manual ready indicator (Illuminates Green when ready)
6. Power indicator (Illuminates red when power is on)
7. Adjust the amount of Haze released (between 0 – 100%)
NOTE: The below controls are only used when in timer mode
8. Adjust the interval gap between each release of Haze (between 0 – 30 Min approximately)
9. Adjust the duration the Haze / Haze is released at each interval (between 0 – 15 seconds approximately).
For best results select "continuous" and adjust output to achieve desired effect, note it can take around 30 seconds for
the machine to produce the correct output.
User manual MAQUINA DE NIEBLA-HAZE MACHINE | Rev. May 2014
DMX Scale
000-255
00-255
Detail Function
0%-100% Fan Speed
0%-100% Haze Output
Publicidad
