Publicidad
Idiomas disponibles
Idiomas disponibles
may be too tight upon cooling. Check the "cold tension" before
next use. The chain must be re-tensioned whenever the flats
on the drive links hang out of the bar groove (Fig. 29).
Fig. 29
Properly Adjusted Warm Chain
Flats are not
visible here
Approximately .050 in. (1.25 mm)
Chain Needs Tensioning
Flats are
visible here
NOTE: A new chain tends to stretch. Check the chain tension
frequently and re-tension as needed.
Nuts + Screws
Periodically check that all the nuts and screws are
tightened securely.
Chain Sharpening
m
WARNING!
To ensure that the chain saw works safely
and efficiently, it is essential that the cutting components are
well-sharpened. It is highly recommended to replace the
chain once it loses its ability to cut cleanly and safely.
It is possible, however, to sharpen the existing chain if the
sharpening is carefully performed. Any work on the chain
and bar requires specific experience and special tools. For
safety purposes, we recommend you contact an authorized
Snow Joe
+ Sun Joe
dealer or call the Snow Joe
®
®
Sun Joe
customer service center at 1-866-SNOWJOE
®
(1-866-766-9563).
Sharpening is necessary when:
• the sawdust looks like dust;
• cutting becomes more difficult;
• the cut is not straight;
• vibrations increase.
An authorized service center will sharpen the chain using the
right tools to ensure minimum removal of material and even
sharpness on all the cutting edges.
If you sharpen the chain yourself, use special round-section
files with the right diameter depending on the type of chain
(see "Chain Maintenance Table" on page 22). You need a
certain amount of skill and experience to avoid damaging the
cutting edges.
Sharpen the chain as follows (Fig. 30):
• Secure the bar firmly, with the chain mounted, in a
suitable vice.
• Tighten the chain if it is loose.
• Mount the file in the guide and then insert it in the tooth at
a constant angle from the cutting edge.
• Sharpen in a forward motion a few times and repeat this
on all the cutting edges facing the same way (right or left).
• To move the chain forward, use a screwdriver.
• Turn the bar over in the vice and repeat on all the other
cutting edges.
• Check that the depth limiter tooth does not stick out
farther than the inspection tool and file any projecting
parts with a flat file, rounding off the edges (Fig. 30).
• After sharpening, remove all traces of filing and dust
and lubricate the chain in an oil bath. Replace the chain
whenever:
– the length of the cutting edges decreases to 5 mm
or less;
– there is too much play between the links and the rivets.
Fig. 30
+
®
Cutting edge
Guide Bar Maintenance
When the guide bar shows signs of wear, turn it over on the
saw to distribute the wear for maximum bar life. Feathering or
burring of the bar rails is a normal process of bar wear. You
should smooth such faults with a file as soon as they occur.
19
Inspection tool
Depth
limiter
tooth
Depth limiter tooth
Publicidad
