Publicidad
Idiomas disponibles
Idiomas disponibles
Product components Installation (Fig. 3.1)
– Sensor
– Mounting frame
Product components Installation (Fig. 3.2)
– Sensor
– Mounting frame
– Surface-mounting adapter
Product dimensions, concealed
installation (Fig. 3.3)
Product dimensions, surface-mounted
installation (Fig. 3.4)
Detection zone (Fig. 3.5)
Note:
The CO2 sensor used in the multisensor
comes with an auto-calibration function.
For this to work properly and ensure
correct measurement by the CO2 sensor,
the multisensor must be permanently
connected to the power supply.
Furthermore, the first seven days after
switching on the power supply may show
major variations in the levels measured.
The sensor must also be exposed to
fresh air for at least an hour a day.
4. Installation
Wiring diagram (Fig. 4.1)
5. Mounting
• Check all components for damage.
• Do not use the product if it is damaged.
• Select an appropriate mounting loca-
tion, taking the reach and presence
detection into consideration.
• Switch OFF power supply (Fig. 4.1)
Mounting procedure, concealed
installation
– Firmly screw the mounting frame onto
the mounting box (Fig 5.1)
– Make plug connection (Fig. 5.2)
– Position sensor on the mounting frame
(Fig. 5.3)
• The sensor is held on the frame by
magnetic force.
Mounting procedure, surface-mounted
installation
– Drill holes and screw on surface-
mounting adapter (Fig. 5.4)
When mounting with exposed cable,
break out the mounting tab (Fig. 5.4)
– Firmly screw the mounting frame
onto the surface-mounting adapter
(Fig 5.5)
– Make plug connection (Fig. 5.6)
– Position sensor on the mounting frame
(Fig. 5.7)
• The sensor is held on the frame by
magnetic force.
Note:
When setting the reach, the mounting
height needs to be specified via the ETS
Note:
Surface-mounted installation has influ-
ences on the sensor variables measured.
For this reason, correction factors are
implemented in the software which take
effect by activating the "surface mount-
ing" type of installation in the ETS.
6. Function and settings
Factory settings
– See KNX application description
– 14 –
Publicidad
