Sthor 78138 Manual Original página 14

EN
Repairs
Repair the power tool only in authorized facilities using only original spare parts. This ensures proper operation safety of
the power tool.
SAFETY WARNINGS FOR RECIPROCATING SAWS
Hold the power tool by its insulated grip surfaces while performing operations where the cutting part may come into
contact with concealed cables. If the cutting part comes into contact with live cable, it may cause the exposed metal parts of the
power tool to become live and electrocute the operator.
Use clamps or other practical means to securely fasten and support the workpiece on a stable platform. Holding the
workpiece with your hand or pressed against your body makes it unstable and can lead to loss of control.
EQUIPMENT INSTALLATION
CAUTION! Only install the equipment when the supply voltage is disconnected. Remove the battery from the power tool
socket!
The saw is supplied complete. After opening the packaging, check that all accessories are included.
PREPARING FOR WORK
Caution! All activities related to the assembly and replacement of saw blades, adjustment and maintenance of the power
tool should be carried out with the power supply to the tool switched off . Therefore, before proceeding with these activ-
ities: Remove the battery from the power tool socket!
PREPARING FOR WORK
CAUTION! All operations mentioned in this section must be done with the power supply disconnected – the battery must be
disconnected from the tool!
Safety instructions for battery charging
Caution! Before starting charging, make sure that the power unit body, cable and plug are not cracked or damaged. It is forbidden
to use a defective or damaged charging station and power unit! Use only the supplied charging station and power unit to charge
the batteries. The use of another power unit may result in fi re or damage to the tool. The battery should only be charged in a
closed, dry room, protected against unauthorised access, especially by children. Do not use the charging station and power unit
without the constant supervision of an adult! If you need to leave the room where the product is being charged, disconnect the
charger from the mains by removing the power unit's plug from the mains socket. If smoke, suspicious odours, etc. are escaping
from the charger, remove the charger plug from the mains socket immediately!
The device is supplied with an uncharged battery and should therefore be charged according to the procedure described below
with the included power unit and charging station before use. Li-ion (lithium-ion) batteries do not have the so-called "memory
eff ect", which means they can be recharged at any time. However, it is recommended to discharge the battery during normal op-
eration and then charge it to full capacity. If, due to the nature of work, it is not possible to use the battery in such a manner every
time, it should be done at least every several work cycles. Never discharge any batteries by short-circuiting the battery plates,
as this will cause irreparable damage! In addition, do not check the battery charge status by short-circuiting the electrodes and
checking their sparking.
Storing the battery
Ensure the proper storage conditions to extend the battery's life. The battery can withstand approximately 500 charge-discharge
cycles. Store the battery at a temperature ranging from 0ºC to 30ºC at a relative air humidity of 50%. Charge the battery to approx.
70% of its total capacity to store it for a longer period of time. In case of prolonged storage, the battery should be periodically
charged once a year. Do not over-discharge the battery as this will shorten its life and may cause irreparable damage.
During storage, the battery will gradually discharge due to leakage. The self-discharge process depends on the storage temper-
ature – the higher the temperature is, the faster the discharge process is. If the batteries are stored incorrectly, the electrolyte
may leak. In case of leakage, secure the leak with a neutralising agent. In the case of electrolyte contact with eyes, rinse eyes
thoroughly with water, and immediately seek medical attention. It is not allowed to use the tool with a damaged battery.
If the battery is completely worn, return it to a specialist waste disposal centre.
Transporting the batteries
Lithium-ion batteries are treated as hazardous goods according to legal regulations. The user of the tool can transport the product
together with the battery and the batteries alone by land. In that case, no additional conditions have to be met. If you entrust trans-
port to third parties (e.g. a courier company), follow the regulations regarding the transport of hazardous goods. Before shipping,
please contact a properly qualifi ed person.
O R I G I N A L I N S T R U C T I O N S
14